Relay access check in emailadmin wizard

[tarantir]

While this may seem like a good idea, it causes the test messages to be unnecessarily queued and stuck retrying.

// try sending a mail to a different domain, if not authenticated, to see if that’s required
if (empty($content[‘acc_smtp_username’]))
{
$smtp->send($content[‘ident_email’], ‘noreply@example.com’, ‘’);
$content[‘smtp_output’] .= “\n”.lang(‘Relay access checked’)."\n";
}

[Ralf_Becker_Stylite]

Hi,

While this may seem like a good idea, it causes the test messages to be
unnecessarily queued and stuck retrying.

// try sending a mail to a different domain, if not authenticated, to see if
that’s required
if (empty($content[‘acc_smtp_username’]))
{
$smtp->send($content[‘ident_email’], ‘noreply@example.com’, ‘’);
$content[‘smtp_output’] .= “\n”.lang(‘Relay access checked’)."\n";
}

I know, but I have not yet implemented a better way to check this AND
target of wizard is to really make sure user entered a working setup.

I could use an existing address eg. discard@egroupware.org …

Ralf

Ralf Becker
Director Software Development

Stylite AG

Morschheimer Strasse 15 | Tel. +49 6352 70629 0
D-67292 Kirchheimbolanden | Fax. +49 6352 70629 30

Email: rb@stylite.de

www.stylite.de | www.egroupware.org

Managing Directors: Andre Keller | Ralf Becker | Gudrun Mueller
Chairman of the supervisory board: Prof. Dr. Birger Leon Kropshofer

VAT DE214280951 | Registered HRB 31158 Kaiserslautern Germany